maybe this was posted somewhere before. couldn't find it.
while using the maxi patch ao i get a very high metric error (2.5-3.5)
everything is working fine accept that there is a slight constant change in the tt velocity meter. (when stopped unless the cut off is set to about 2.15 i get a drag sound) the vinyl i'm using is brand new and there's no noise coming from the turntable (i checked it with with real vinyl).
anythoughts?
this isn't horrible but it does bother me while using it as a midi controller.
error metric
-
- Site Admin
- Posts:1093
- Joined:Mon Jun 07, 2004 9:17 pm
a stanton st-150 (which has a unballanced llatter which some records warp on)
into an audio kontrol-1. no phono pre-amp the st has line level out's.
into a compaq 2ghz 3gb ram windows 7 laptop.
everything actually works fine exept for the unstable velocity read which might be due to the shit turntable i'm using.
but the high error makes me a bit worried.
into an audio kontrol-1. no phono pre-amp the st has line level out's.
into a compaq 2ghz 3gb ram windows 7 laptop.
everything actually works fine exept for the unstable velocity read which might be due to the shit turntable i'm using.
but the high error makes me a bit worried.
-
- Site Admin
- Posts:1093
- Joined:Mon Jun 07, 2004 9:17 pm
-
- Site Admin
- Posts:1093
- Joined:Mon Jun 07, 2004 9:17 pm
-
- Site Admin
- Posts:1093
- Joined:Mon Jun 07, 2004 9:17 pm
It could also be that your needle needs to be replaced. When a needle starts to go bad, it introduces lots of distortion to the signal, and it's intermittent.
Here'a PDF that everyone should read about how to get the best performance from vinyl control with Ms Pinky:
http://www.mspinky.com/Some_Technical_Info_on_VInyl.pdf
Here'a PDF that everyone should read about how to get the best performance from vinyl control with Ms Pinky:
http://www.mspinky.com/Some_Technical_Info_on_VInyl.pdf