Hello
XP64bit
Edirol FA-101
Gen 4 45RPM Vinyl
2 BBE FJB-200X Phono Preamps
technic 1200
shure whitelabel
Pinky VST
and
Maxi Patch AO
I can't get absolute to work, relative works fine. When I switch it to absolute the vinyl annimation goes crazy and the song position skips. I have tried ground to the preamp and to the mixer and the same thing happens.
thanks
45 RPM HQ-180 vinyl: Absolute mode not Working?
-
- Site Admin
- Posts:1093
- Joined:Mon Jun 07, 2004 9:17 pm
See this post and the answer:
http://www.mspinky.com/phpBB2/viewtopic.php?t=980
All you have to do is select "Torq" vinyl in the vinyl control settings.
http://www.mspinky.com/phpBB2/viewtopic.php?t=980
All you have to do is select "Torq" vinyl in the vinyl control settings.
thanks that worked.
Now I am experiencing this on the ;eft deck. When the needle is in contact all works as intended. When I take the needle off the vinyl position moves slowly in reverese.......like its getting some of a signal, but it shouldn't be.
Could this be a grounding issue? Or something wrong with the table? The other deck is not doing this.
Now I am experiencing this on the ;eft deck. When the needle is in contact all works as intended. When I take the needle off the vinyl position moves slowly in reverese.......like its getting some of a signal, but it shouldn't be.
Could this be a grounding issue? Or something wrong with the table? The other deck is not doing this.
-
- Site Admin
- Posts:1093
- Joined:Mon Jun 07, 2004 9:17 pm